19. Mast | 19. マスト |
|||||
(a) | To prevent abrasion of the mast step, a tube or collar of uniform thickness not exceeding 1 mm may be placed around the entire circumference of the lower mast or the mast step cavity. | (a) | マストステップの摩耗を防ぐため、1mm 未満の均一な厚さのチューブやカラーを 1個、ボトムマストまたはマストホールの全周にわたって取り付けてもよい。 | |||
The tube or collar shall not extend more than 10 mm above deck level. | このチューブまたはカラーは、デッキレベルから 10mm よりも上に出てはならない。(2019年 変更) | |||||
In addition, a disc of uniform thickness not exceeding 1 mm in thickness may be placed in the bottom of the mast step. | また、1mm 未満の均一な厚さの円板を 1枚、マストホールの底に取り付けてもよい。 | |||||
(b) | The mast or mast cavity may be lubricated. | (b) | マストやマストホールを潤滑してもよい。 | |||
(c) | Tape or other bushing material may be applied to both the plastic end cap, the collar of the upper mast and the upper mast to ensure a snug fit. | (c) | ガタのないはめ合わせを得るため、トップマストのプラスチック製エンドプラグ、マストカラー、トップマスト本体に、テープやその他のブッシング材を使用してもよい。 | |||
The tape or bushing material may only be used on that portion of the plastic parts that actually slide into the lower section and/or between the upper mast and the collar and it shall be a uniform thickness around the circumference. | テープやブッシング材の使用は、ボトムマストの中に入りこむプラスチックの部分、およびトップマストとマストカラーの間のすきまに限られ、その厚さは全周にわたって均一でなければならない。 | |||||
Taping or bushing material above the collar to fair the collar into the mast is prohibited. | マストカラーからトップマストにかけての形状を整えるための、マストカラーより上方へのテーピングやブッシング材の使用は禁止する。 | |||||
(d) | Flexible adhesive tape may be applied to the outside of the joint of the upper and lower mast sections to a limit of 40 mm above and below the joint to prevent rotation of the mast sections at the joint. | (d) | トップマストとボトムマストが接合部で回転するのを防ぐために、その接合部の外側に、継ぎ目の上下 40mm の範囲内で柔軟性のある粘着テープを貼ってもよい。 | |||
ILCA By-Law 1: Rules クラス規則2018